Japanese Plane Secrets 5

 

Fitting a blade and Back Iron to the body.

Fitting the blade and back iron to the body is a fiddle, but not difficult. What you need is a good bench light and a graphite pencil or graphite stick. The essance is  of this is DO NOT CHANGE THE GEOMETRY of the plane body. So as the blade fits into the two side channels do not pare the upper surface this is the surface that beds the blade at 41 degrees effective pitch.

DSC_2782

Remove the bar under which the back iron fits you will find that this is just a round wire nail sharpened on one end. Fit the blade rubbing graphite on the sides and on the back of the blade.

DSC_2806

Tap the blade in using a small hammer, tap it out by hitting the top back corner with the hammer, there is a camfer planed on that corner to allow you hit JUST THERE. Not on the end like European tap and try planes.

DSC_2777

Where the graphite has left an imprint on the plane body pare that away and repeat the process. You will find yourself fitting the width first then paring to allow the back of the blade to sit further down the body of the plane . Allow a nice couple of hours to do this well. If you rush this the blade will not sit tight as it is working and you will not get the polish you want.

Remember that plane bodies expand and contract in width and blades do not so open the side channels enough to allow for this expansion and contraction. You see so many cracked Kanna where this has not been done correctly.

Getting a good fit for the back iron is difficult as it is hard to see right down by the cutting edge. You will need a narrow chisel for the slots on either side and broad chisel for the land between.

IMG_1044

The mouth is pretty well determined by the Kanna maker a good maker will set up the mouth so that the blade trims its own mouth and you can then open it a shaving or two. I have a Kanna that did not have such a good mouth so I have fitted a rosewood dovetailed key in front of the blade .

IMG_1046

Next we will look at the sole of the plane and taking a shaving or two!

 

David established Rowden Atelier in 1995, a now world renowned fine woodworking school. Discover Rowden, the woodworking courses, and the work that students go on to do.

Looking for our woodworking courses?

Rowdenatelier.com is the new home of Rowden Atelier Fine Woodworking School.

It is where you will now find all the information about our renowned fine woodworking courses, our ethos, and why our students go on to do so many great things. This site remains dedicated to the designs and work, of Rowden’s Founder; David Savage. If you are looking for our woodworking courses, please click here.